Confirm the design
Check voltage windows, current ratings, protection devices, cable sizes, communication and environmental limits.
Before energising
Four essential stages
Inspect installation
Verify mounting, ventilation, clearances, grounding, polarity, torque and isolation before connecting power.
Configure safely
Use the approved parameter set for the battery, inverter, grid standard and intended operating mode.
Record commissioning
Capture serial numbers, firmware, settings, initial readings and acceptance results for future service.
Important
Use the model-specific manual
This page is a general workflow for site planning. It is not a substitute for qualified electrical design, local regulations or the instructions supplied with the installed model.
Open DownloadsQualified personnelRequired for installation and service
Local codeMust be followed
PPE and isolationUse defined site procedures
RecordsKeep commissioning evidence